First AMB82-Mini Project (Blink)

Technical Discussion
,
1

When I connect the board to my computer via the MicroUsb port, it is found and registered as a USB Serial Port. Within the IDE I open a new project Blink and select the port and board for the device. Now I clicked on Verify, when verified, I clicked on Start Debugging. It spins for a second, then a window pops open on the lower right of the IDE saying the following:

“Device Identifier is required for J-Link configurations. Please see Supported Devices for supported devices”

I am not sure what this means, when I watched the youtube video this did not happen. How do I proceed?

2

I’ve figured it out. Apparently I should not have been selecting Start Debugging. When I select Sketch->Upload it works fine.

2 Likes