AMB82-mini: how to disable the always-on red LED?

The red LED near the USB connector on the AMB82-mini stays on all the time. Can it be turned off from software with the FreeRTOS SDK (GPIO, register or config option)?

If not, which component is better and safer to desolder: the LED or its series resistor? Please share the reference designator.

Thanks!

I have poured over the SDK and it seems the red LED is hardwired. I believe desoldering it should be safe.

Hi @inxnik,

The red LED cannot be controlled via Software (GPIO, register, or FreeRTOS config), as it is typically hardwired to the power supply and not connected to any GPIO.

You can refer to AMB82-mini Hardware Design Kit (HDK) .

If you would like to disable the red LED, you can do so by desoldering R58. However, please note that the red LED serves as a power indicator to confirm that the 3.3V power supply is functioning normally.

R58 is the series resistor, so removing it is the cleaner target than the LED if you only need to kill the indicator: it interrupts the LED current without disturbing the LED pads. You’ll lose the 3.3 V power indicator either way. If reversibility matters, try opaque tape over the LED before doing any board rework.